TIP: For information on setting up Tunnel All Mode for Site to Site VPNs reference How to configure Tunnel All Internet Traffic over Site to Site VPN. This occurs when the GVC Client or VPN Peer is attempting to use Tunnel All / Route All Mode but the SonicWall isn't configured to do so. IKE Responder: Proposed remote network 0.0.0.0 but not DHCP relay nor default route.IKE Phase 1 information doesn't match across the Local and Remote VPN Concentrators. IKE Responder: IKE proposal does not match (Phase 1) IKE Responder: No matching phase 1 ID found for proposed remote network.Indicates the Remote VPN device is attempting to use Transport Mode, SonicWall devices only support Tunnel Mode. IKE Responder: Mode %d ' Not Tunnel Mode.Mismatched information can include any of the following:ĬAUTION: Every setting must be an exact match on both sides of the VPN or the SonicWall will not create the Security Association. In the case of a VPN Policy this indicates that the Phase 2 information doesn't match across the local and remote devices. IKE Responder: IPSec Proposal does not match (Phase 2).Examine the GVC Policy under VPN | Settings and ensure Manual Configuration is selected on the Client tab under Virtual Adapter Settings. In this situation a GVC Client is attempting to use a Static IP Address when that configuration is not supported in the GVC Policy. IKE Responder: %s Policy does not allow Static IP for Virtual Adapter.TIP: You can view the DHCP Relay Table by navigating to VPN | DHCP over VPN | Configure. This is commonly encountered when using Static IPs for GVC Users, and can be resolved by not using the IP Address in the DHCP Relay Table, or by using DHCP for GVC connections. The GVC User/Client is attempting to use an IP Address that is already used in the SonicWall DHCP Relay Table. IKE Responder: IP address already exists in the DHCP Relay table.Indicates the SonicWall Appliance needs to be Registered prior to utilizing GVC.Global VPN Client connection is not allowed.Deleting the GVC Connection on the Client (User Side) and re-adding it will resolve this. This indicates the SonicWall is not allowing Phase 2 negotiation using Simple Keys. Blocked Quick Mode for Client using Default Key ID.TIP: To view the amount of GVC Licensed Connections your device has navigate to System | Licenses and look for GVC. The SonicWall has reached either its limit of Device GVC Connections, or its limit of Licensed GVC Connections.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |